Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod CON1

The Pmod CON1 is a small module with six screw terminals to interface with external wires that are not compatible with the DIP standard. Two of the terminals can be used to provide power from an outside source and the other four can be used for data signals.

Features

Six screw terminals
- Four screw terminals for data signals
- Two screw terminals for external power
Small PCB size for flexible designs 1.1“ × 0.8” (2.8 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod CON1

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod CON1: Wire Terminal Connectors
Manufacturer's article number: 410-065

Resources

Other Digilent products are available on request.

ID articolo	100205
Condizione
ID della variazione	1898
Modello	410-065
Produttore	Digilent Inc.
Paese di produzione
Contenuto	1 undefined
Peso	19 g
Peso netto	19 g

Pmod CON1: Wire terminal connectors