Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod CON3

The Pmod CON3 can be easily used to interface with up to four small servo motors that deliver anywhere from 50 to 300 ounce/inches of torque, such as those used in radio controlled airplanes or cars, as well as some mechatronics projects. The power supply can be sourced either from the system board or an external power source via a pair of screw terminals.

Features

Four standard 3-wire servo motor connectors
Easily interface with Digilent system boards
Flexible power delivery to servos
Small PCB size for flexible designs 1.0 in × 0.8 in (2.5 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod CON3

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod CON3: R/C Servo Connectors
Manufacturer's article number: 410-082

Resources

Other Digilent products are available on request.

ID de l’art.	100226
État
ID de l'ancien article	1935
Modèle	410-082
Fabricant	Digilent Inc.
Pays de fabrication	Taiwan
Contenu	1 pièce
Poids	15 g
Poids net	15 g

Pmod CON3: R/C Servo Connectors