Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod OD1

The Pmod OD1 is an open drain FET module using NTHD4508 transistors. Users can then drive high current devices (up to 4.1A) by providing digital logic signals from the host board.

Features

Two dual power N-FETs
Comfortable drives 3.0 A of continuous current
4.1 A peak output current (t < 5 s)
20 V maximum output voltage
Four output clamp diodes
Small PCB size for flexible designs 1.2“ × 0.8” (3.0 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod OD1

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod OD1: Open Drain Output
Manufacturer's article number: 410-125

Resources

Other Digilent products are available on request.

ID de l’art.	100208
État
ID de l'ancien article	1904
Modèle	410-125
Fabricant	Digilent Inc.
Pays de fabrication	Taiwan
Contenu	1 pièce
Poids	20 g
Poids net	20 g

Pmod OD1: Open drain output